Skip to content
statance
MenuClose
← All troubleshooting guides

High swap usage on Linux

Linux

Swap in use is not a problem by itself; active swapping is. Run vmstat 1 and look at the si and so columns: if they stay non-zero, the server is moving memory to and from disk and is short of RAM. Find the processes using the most memory and reduce them, or add RAM.

Symptoms

  • free -m shows swap used growing
  • Server becomes very slow under load
  • High iowait with the swap device busy

How to diagnose it

  1. Check swap and available memory

    Low available memory and high swap together mean pressure.

    free -m swapon --show
  2. Check whether swapping is happening now

    si is memory swapped in, so swapped out, per second. Sustained non-zero values mean active swapping.

    vmstat 1 10
  3. Find which processes are swapped out

    VmSwap in each process’s status file shows its swapped memory.

    for f in /proc/[0-9]*/status; do awk '/^Name|^VmSwap/{printf "%s ", $2} END{print ""}' "$f"; done 2>/dev/null | sort -k2 -rn | head
  4. Check swappiness

    Default is usually 60. Lower values make the kernel prefer dropping cache over swapping applications.

    cat /proc/sys/vm/swappiness

Common causes and fixes

Not enough RAM for the workload

Reduce memory use (fewer workers, smaller caches) or resize the server.

Old, idle pages swapped out long ago

If si/so are zero, swap use is harmless. To pull pages back into RAM when memory is plentiful, cycle swap.

sudo swapoff -a && sudo swapon -a # only when free RAM exceeds used swap

Swappiness too high for a database server

Lower it so the kernel keeps application memory resident.

echo "vm.swappiness=10" | sudo tee /etc/sysctl.d/99-swappiness.conf sudo sysctl --system

Memory leak

A process whose RSS keeps growing pushes everything else into swap. Restart it and fix the leak.

Prevent it happening again

  • Alert when SWAP_used is above 50% for 10 minutes.
  • Alert on MEM_used above 90% so you see pressure before swapping starts.
  • Watch CPU_iowait; swapping shows up as disk wait.

Set it up: Linux monitoring · Ubuntu monitoring.

FAQ

Is it bad if Linux is using swap?

Not necessarily. The kernel moves idle pages to swap to make room for cache. It is only a problem when pages are swapped in and out continuously.

How do I clear swap in Linux?

Run sudo swapoff -a && sudo swapon -a, but only when available RAM is larger than used swap, otherwise the OOM killer may run.

How much swap should a server have?

For most servers 1–4 GB or about half of RAM on small machines is enough as a safety margin. Swap is not a substitute for RAM.

Related guides

Get alerted before this becomes an outage.

Install the agent in one line. Statance watches CPU, memory, disk and services, and its AI assistant helps find the cause.